LDV-A Senior Mechanical and Rotating Equipment Commissioning Engineer
Essential Duties & Responsibilities
To delineate all commissioning test pack boundaries.
Input to the design review sufficient to ensure they meet the needs of the commissioning team.
To ensure that the commissioning planning is prepared in detail following the priorities.
To ensure that the Mechanically complete systems are properly handed over to the Onshore Commissioning Team and are fully pre-commissioned as far as practical and that the systems are then fully onshore commissioned as far as possible without the use of live hydrocarbons.
To carry out the necessary retesting offshore plus to complete the commissioning offshore including offshore start up and commissioning with live hydrocarbons and to ensure the systems are adequately performance tested.
To ensure a full suite of pre-commissioning and commissioning and start up procedures are prepared.
To ensure that detailed commissioning test procedures are provided for all systems.
To ensure that a set of handover dossiers are prepared.
To ensure the systems are mechanically complete and pre-commissioned in sufficient time to meet the stated objectives.
To ensure that all required vendor specialists are available to support commissioning.
To ensure that start up and commissioning spares are available to support the commissioning.
To interface with the pre-operations team to ensure a smooth handover and acceptance of the systems by Operations.
Ensure that all LR/VR certification requirements are met.
Experience & Education
Maximum age 50 years of age.
Must have high degree of physical fitness.
Have (min 20 years) working Experience in Oil & gas related Commissioning of which 10 years must be on offshore facilities.
Must be familiar with gas turbine driven generators and gas turbine driven centrifugal compressor packages plus the normal range of mechanical packages found on offshore CPPs.
Have worked in S.E.A. for at least 5 years.
Extensive experience in the preparation of mechanical completion and commissioning databases.
Extensive experience in punchlist management.
Shall have a mechanical and rotating equipment background.
Fluent in English both written and spoken.
Selection of manpower, qualification and management.
